Product Description
Input voltage range: DC 3.3V to 5V
Output signal: The module has two analog output and one digital output interface. The output values correspond to (X, Y) two-axis offset respectively
It can be programmed by Arduino controller, and the sensor expansion board can be plugged in to complete the creative remote interactive work.
The cross rocker is a bidirectional 10K resistor, and the resistance of the tap changes with the direction of the rocker.
This module uses 5V power supply. In the original state, the X and Y read voltages are about 2.5V. When pressed in the direction of the arrow, the read voltage value increases with the maximum value to 5V.
Output signal: The module has two analog output and one digital output interface. The output values correspond to (X, Y) two-axis offset respectively
It can be programmed by Arduino controller, and the sensor expansion board can be plugged in to complete the creative remote interactive work.
The cross rocker is a bidirectional 10K resistor, and the resistance of the tap changes with the direction of the rocker.
This module uses 5V power supply. In the original state, the X and Y read voltages are about 2.5V. When pressed in the direction of the arrow, the read voltage value increases with the maximum value to 5V.
Related Products

3.7V 3 Slot 18650 Battery hold...
RWF 1,500

5KG Digital Load Cell Weight S...
RWF 7,500

5V Active Buzzer
RWF 700
RWF 500

MCP2515 CAN BUS Module Compati...
RWF 4,300